4_2021_sen_2

Title of the article LIFETIME OF HIGH-PARAMETER STRUCTURES UNDER REPEATED AND PROLONGED THERMOMECHANICAL INFLUENCES
Authors

BONDAR Valentin S., D. Sc. in Phys. and Math., Prof., Professor of the Department of Technical Mechanics, Moscow Polytechnic University, Moscow, Russia, This email address is being protected from spambots. You need JavaScript enabled to view it.">This email address is being protected from spambots. You need JavaScript enabled to view it.

ABASHEV Dmitriy R., Ph. D. in Phys. and Math., Assoc. Prof., Associate Professor of the Department of Technical Mechanics, Moscow Polytechnic University, Moscow, Russia, This email address is being protected from spambots. You need JavaScript enabled to view it.">This email address is being protected from spambots. You need JavaScript enabled to view it.
In the section DYNAMICS, DURABILITY OF VEHICLES AND STRUCTURES
Year 2021
Issue 4(57)
Pages 20–26
Type of article RAR
Index UDK 539.374
DOI https://doi.org/10.46864/1995-0470-2021-4-57-20-26
Abstract The article considers the main provisions and equations of the applied theory of inelasticity, which belongs to the class of flow theories under combined hardening. The material functions that close the applied theory of inelasticity are distinguished, and a basic experiment is formulated. The prediction of the material lifetime of structures under non-isothermal cyclic loads is carried out on the basis of the analysis of the durability of the combustion chamber edge of the diesel piston and the uncooled conical nozzle tip during heat changes. Calculated lifetime estimates based on the applied theory of inelasticity are compared with the results of experiments and traditional methods of lifetime estimation. Examples of estimating the lifetime of a structural element of a long-term lifetime power unit are also considered. The loading modes leading to a significant reduction in the lifetime are shown.
Keywords inelasticity, lifetime, durability, non-isothermal cyclic loads, damage accumulation
  You can access full text version of the article.
Bibliography
  1. Bondar V.S. Neuprugoe povedenie i razrushenie materialov i konstruktsii pri slozhnom neizotermicheskom nagruzhenii. Diss. dokt. fiz.-mat. nauk [Inelastic behavior and destruction of materials and structure under complex non-isothermal loading. D. Sc. Thesis]. Moscow, 1990. 314 p. (in Russ.).
  2. Bondar V.S. Neuprugost. Varianty teorii [Inelasticity. Variants of the theory]. Moscow, FIZMATLIT Publ., 2004. 144 p. (in Russ.).
  3. Bondar V.S., Danshin V.V. Plastichnost. Proportsionalnye i neproportsionalnye nagruzheniya [Plasticity. Proportional and disproportionate loads]. Moscow, FIZMATLIT Publ., 2008. 176 p. (in Russ.).
  4. Bondar V.S. Inelasticity. Variants of the theory. New York, Begell House, 2013. 194 p.
  5. Chaboche J.L., Rousselier G. On the plastic an viscoplastic constitutive equations. Journal of pressure vessel technology, 1983, vol. 105, iss. 2, pp. 153–164.
  6. Chaboche J.L. Constitutive equation for cyclic plasticity and cyclic viscoplasticity. International journal of plasticity, 1989, vol. 5, no. 3, pp. 247–302.
  7. Chaboche J.L. Thermodynamically based viscoplastic constitutive equations: theory versus experiment. Proc. ASME Winter Annual Meeting. Atlanta, 1991, pp. 1–20.
  8. Chaboche J.L. Cyclic viscoplastic constitutive equations. Journal of applied mechanics, 1993, vol. 60, iss. 4, pp. 813–828.
  9. Chaboche J.L. A review of some plasticity and viscoplasticity constitutive theories. International Journal of Plasticity, 2008, vol. 24, iss. 10, pр. 1642–1693.
  10. Kachanov L.M. Teoriya polzuchesti [Creep theory]. Moscow, FIZMATLIT Publ., 1960. 455 p. (in Russ.).
  11. Ilyushin A.A. Plastichnost. Osnovy obshchey matematicheskoy teorii [Plasticity. Fundamentals of general mathematical theory]. Moscow, AN SSSR Publ., 1963. 271 p. (in Russ.).
  12. Ilyushin A.A. Mekhanika sploshnoy sredy [Continuum mechanics]. Moskovskiy gosudarstvennyy universitet Publ., 1990. 310 p. (in Russ.).
  13. Volkov I.A., Korotkikh Yu.G. Uravneniya sostoyaniya vyazkouprugoplasticheskikh sred s povrezhdeniyami [Equations of state for damaged viscoelastoplastic media]. Moscow, FIZMATLIT Publ., 2008. 424 p. (in Russ.).
  14. Volkov I.A., Igumnov L.A., Korotkikh Yu.G. Prikladnaya teoriya vyazkoplastichnosti [Applied theory of viscoplasticity]. Nizhny Novgorod, Nizhegorodskogo gosudarstvennogo universiteta Publ., 2015. 317 p. (in Russ.).
  15. Krempl E. The influence of state of stress on low-cycle fatigue of structural materials: a literature survey and interpretive report. ASTM Special Technical Publication, no. 549, 1974.
  16. Krempl E., Lu H. The hardening and dependent behavior of fully annealed AISI Type 304 stainless steel under biaxial in-phase and out–of–phase strain cycling at room temperature. Journal of engineering materials and technology, 1984, vol. 106, iss. 4, pp. 376–382.
  17. Krieg R.D. A practical two surface plasticity theory. Journal of applied mechanics, 1975, vol. 42, iss. 3, pp. 641–646.
  18. Krieg R.D., Swearengen J.C., Rhode R.W. A physically based internal variable model for rate-dependent plasticity. Inelastic behavior of pressure vessel and piping components, 1978, pp. 15–28.
  19. Lindholm U.S., Chan K.S., Bodher S.R., Weber R.M., Walker K.P., Cassenti B.N. Constitutive modeling for isotropic materials (HOST). Second annual status report, NASA CR 174980, 1985.
  20. Malinin N.N. Prikladnaya teoriya plastichnosti i polzuchesti [Applied plasticity and creep theory]. Moscow, Mashinostroenie Publ., 1975. 400 p. (in Russ.).
  21. Miller A.K. A unified approach to predicting interactions among creep, cyclic plasticity, and recovery. Nuclear engineering and design, 1978, vol. 51, iss. 1, pp. 35–43.
  22. Miller K.J., Brown M.W. Multiaxial fatigue: a brief review. Advances in fracture research. Proc. 6th International Conference. New Delhi, 1984, vol. I, pp. 31–56.
  23. Miller A.K., Tanaka T.G. NONSS: A new method for integrating unified constitutive equations under complex histories. Journal of engineering materials and technology, 1988, vol. 110, iss. 3, pp. 205–211.
  24. Novozhilov V.V., Kadashevich Yu.I. Mikronapryazheniya v konstruktsionnykh materialakh [Micro-stresses in structural materials]. Leningrad, Mashinostroenie Publ., 1990. 224 p. (in Russ.).
  25. Ohno N. A constitutive model of cyclic plasticity with a nonhardening strain region. Journal of applied mechanics, 1982, vol. 49, iss. 4, pp. 721–727.
  26. Ohno N. Recent topics in constitutive modeling of cyclic and viscoplasticity. Applied mechanics reviews, 1990, vol. 43, iss. 11, pp. 283–295.
  27. Ohno N., Wang J.D. Transformation of a nonlinear kinematics hardening rule to a multisurface form under isothermal and nonisothermal conditions. International journal of plasticity, 1991, vol. 7, iss. 8, pp. 879–891.
  28. Ohno N., Wang J.D. Kinematics hardening rule with critical state of dynamic recovery. International journal of plasticity, 1993, vol. 9, iss. 3, pp. 375–403.
  29. Rabotnov Yu.N. Polzuchest elementov konstruktsiy [Creep of structural elements]. Moscow, Fizmatgiz Publ., 1966. 752 p. (in Russ.).
  30. Besson J., Cailletaud G., Chaboche J.-L., Forest S. Mécanique non linéaire des matériaux. Hermès – Lavoisier, 2001. 446 p.
  31. Temis Yu.M. Modelirovanie plastichnosti i polzuchesti konstruktsionnykh materialov GTD [Modeling of plasticity and creep of structural materials of gas turbine engines]. Prioritety razvitiya otechestvennogo avtotraktorostroeniya i podgotovki inzhenernykh nauchnykh kadrov. Materialy 49 Mezhdunarodnoy nauchno-tekhnicheskoy konferentsii AAI. Shkola-seminar “Sovremennye modeli termovyazkoplastichnosti” [Priorities of development of domestic automotive industry and training of engineering scientific personnel. Proc. 49th International Scientific and Technical Conference of Association of Automotive Engineers. School-seminar “Modern models of thermoviscoplasticity”]. Moscow, 2005, p. 2, pp. 25–76 (in Russ.).
  32. Vasin R.A. Eksperimentalno-teoreticheskoe issledovanie opredelyayushchikh sootnosheniy v teorii uprugoplasticheskikh protsessov. Avtoref. diss. d-ra fiz.-mat. nauk [Experimental and theoretical study of the determining relations in the theory of elastic-plastic processes. Extended Abstract of D. Sc. Thesis]. Moscow, 1987. 36 p. (in Russ.).