Smart Search 



Title of the article

LAW OF FRICTION: FROM TRIBOLOGY TO TRIBO-FATIGUE. REPORT 1. CLASSICAL LAW OF (DRY) FRICTION AND NEED FOR ITS ADJUSTMENT

Authors

SOSNOVSKIY Leonid A., D. Sc. in Eng., Prof., Director, S&P GROUP TRIBOFATIGUE Ltd., Gomel, Republic of Belarus, This email address is being protected from spambots. You need JavaScript enabled to view it.">This email address is being protected from spambots. You need JavaScript enabled to view it.

In the section TRIBO-FATIGUE SYSTEMS MECHANICS
Year 2019 Issue 1 Pages 64–76
Type of article RAR Index UDK 620.178.16; 620.178.3 Index BBK  
Abstract

To date, many laws of Nature have been discovered. The knowledge of each of them led to the accelerated development of the relevant sections of Science and further, as a rule, to progress in any practical area of the  community of  people. The  empirical law of dry friction [1, 2], first formulated by Leonardo da Vinci 500 years ago, went down in  history of  technology as one of the most applicable laws in engineering calculations [3]. Moreover, our worldview is  unthinkable without an understanding of the general processes of movement with friction (as  well as movement without friction). All  this gives grounds to say: “Friction is an amazing phenomenon of nature” (D. Garkunov). Two hundred years later (after da Vinci) Amonton G., Coulomb C.A., and Euler L. [4–7] made a  decisive contribution to  the substantiation and understanding of the law of dry friction, and it became classical: the force of  sliding friction is proportional to  the  contact load. Studies show that the classical friction law for the tribo-fatigue system is  inaccurate and, therefore, inapplicable. It  was established experimentally that the error in estimating the  coefficient of friction in a tribo-fatigue system (for example, a  “wheel – rail” type, etc.) reaches 60...70  % or  more, if we use the classical law of friction for its analysis. Therefore, there is a problem of adjusting the classical law of friction. A set of  theoretical and experimental studies was carried out, the results of which make it possible to formulate a  generalized law of friction: the friction force is  proportional to both contact and non-contact volume loads, if  the  latter excites a  cyclic stress (strain) field in  the friction zone. This law describes all the experimental results (more than 100 values of  the friction coefficient) with an error of no more than ±6  %. The widespread use of the proposed generalized law of  friction in  the engineering is  considered as a very urgent task. In conclusion of the article, some directions for  further research (theoretical and  experimental) are formulated. The article is published in three reports.

Keywords

friction law, tribology, friction pair, tribo-fatigue, tribo-fatigue system, friction force and coefficient, sliding, rolling, slipping, contact load, pressure, non-contact (volume) load, stress, strain

   
Bibliography
  1. Fizicheskiy entsiklopedicheskiy slovar [Physical encyclopaedic dictionary]. Moskow, Bolshaya sovetskaya entsiklopediya Publ., 1983. 928 p.
  2. Encyclopedia of Tribology: in 6 vol. Springer, 2013. 4139 p.
  3. Zhuravlev V.F. 500 let istorii zakona sukhogo treniya [500  years of history of the law of dry friction]. Vestnik MGTU im.   N.E. Baumana. Seriya “Estestvennye nauki” [Herald of  the  Bauman Moscow State Technical University. Series Natural Sciences], 2014, no. 2, pp. 21–31.
  4. Leonardo da Vinchi. Izbrannye estestvenno-nauchnye proizvedeniya [Leonardo da Vinci. Selected natural-scientific works]. Moscow, AN SSSR Publ., 1955. 1028 p.
  5. Amontons M. De la résistance causee dans les machines. Histoire de L’Academie Royale des Sciences, 1699, pp. 206–222.
  6. Euler L. Sur la diminution de la résistance du frottement. Histoire de L’Academie Royale des Sciences et Belles Lettres, 1748, vol. 4, pp. 133–148.
  7. Coulomb C.A. Theorie des machines simples, en ayant égard au frottement de leurs parties, et a la roideur des Cordages. Mémoires de mathématique et de physique, présentés a  l'Académie Royale des Sciences, par divers Savans, et lus dans ses Assemblées, 1785, vol. 10, pp. 161–332.
  8. Blau P.J. Friction science and technology: from concepts to  applications. London, New York, CRC Press, 2009. 420 p.
  9. Kragelskiy I.V., Shchedrov V.S. Razvitie nauki o trenii [Friction science development]. Moscow, AN SSSR Publ., 1958. 234 p.
  10. Dowson D. History of Tribology. London, New York, Longman, 1979. 677 p.
  11. Buyanovskiy I.A., Fuks I.G., Shabalina T.P. Granichnaya smazka: etapy razvitiya tribologii [Boundary lubrication: stages of  tribology development]. Moscow, Neft i gaz Publ., 2002. 230 p.
  12. Morin A. Nouvelles Expériences sur le Frottement Faites á Metz en 1831. Mémoires Présentés par Divers Savans á  l'Académie des Sciences, 1833, vol. 4., pp. 1–128.
  13. Zhukovskiy N.E. Trenie bandazhey zheleznodorozhnykh koles o relsy [The friction of the railway wheels tires on rails]. Sobranie sochineniy: v 16 tomakh [Collected works: in 16  volumes], 1950, vol. 7, pp. 426–478.
  14. Rubenstein С. General theory of the surface friction of solids. Proc. Physical Society, 1956, vol. 69, no. 9, pp. 921–932.
  15. Ling F.F., Saibel E. On kinetic friction between unlubricated metallic surfaces. Wear, 1957, vol. 1, no. 3, pp. 167–172.
  16. Rubenstein С. The coefficient of friction of metals. Wear, 1958, vol. 2, no. 2, pp. 85–96.
  17. Dahl P.R. A solid friction model. The Aerospace Corporation. Technical report TOR-0158(3107-18)-1, 1968. 31 p.
  18. Dahl, P.R. Measurement of solid friction parameters of ball bearings. The Aerospace Corporation. Interim report TR-0077(2901-03)-3,1977. 25 p.
  19. Dowson D. History of tribology. New York, Longman, 1979. 677 p.
  20. Ishlinskiy A.Yu. Mekhanika: idei, zadachi, prilozheniya [Mechanics: ideas, tasks, applications]. Moscow, Nauka Publ., 1985. 624 p.
  21. Alexeyev N.М. On the motion of material in the border layer in  solid state friction. Wear, 1990, vol. 139, pp. 33–48.
  22. Haessig Jr. D.A., Friedland B. On the modeling and simulation of  friction. Journal of Dynamic Systems, Measurement and  Control, Transactions of the ASME, 1991, no. 113(3), pp. 354–362.
  23. Gafvert M. Comparisons of two dynamic friction models. Proc. 1997 IEEE International Conference on Control Applications, Hartford, CT, 1997, pp. 386–391.
  24. Brushan В. Principles and applications of tribology. New York, Willey, 1999. 390 p.
  25. Swevers J., et al. An integrated friction model structure with improved presliding behavior for accurate friction compensation. IEEE Transactions on Automatic Control, 2000, no. 45(4), pp. 675–686.
  26. Lampaert V., Swevers J., Al-Bender F. Modification of the  leuven integrated friction model structure. IEEE Transactions on  Automatic Control, 2002, no. 47(4), pp. 683–687.
  27. Al-Bender F., Lampaert V., Swevers J. A novel generic model at  asperity level for dry friction force dynamics. Tribology Letters, 2004, no. 16(1–2), pp. 81–94.
  28. Jianping G., et al. Frictional forces and Amonton's law: from the molecular to the macroscopic scale. The Journal of Physical Chemistry, 2004, vol. 108, pp. 3410–3425.
  29. Al-Bender F. On the definition and laws of friction. Proc. World Tribology Congress III, Washington, 2005.
  30. Merzlyakov A.A. O vneshnem trenii i zakone treniya [On  external friction and the law of friction]. Omskiy nauchnyy vestnik [Omsk scientific herald], 2006, no. 4(38), pp. 77–81.
  31. Persson B. N. J., et  al. On the origin of Amonton's friction law. Journal of Physics: Condensed Matter, 2008, vol. 20, no. 39, pp. 395006–395017.
  32. Zhuravlev V.F., Klimov D.M. O mekhanizme yavleniya shimmi [The causes of the shimmy phenomenon]. Doklady RAN [Reports of the Russian Academy of Sciences], 2009, vol. 428, no. 6, pp. 761–764.
  33. Popova E., Popov V. On the origin of Amonton's friction law. Friction, 2015, vol. 3, no. 2, pp. 183–190.
  34. Johnson K.L. Contact Mechanics. Cambridge, Cambridge University Press, 1987. 452 p.
  35. Sherbakov S.S., Sosnovskiy L.A. Mekhanika tribofaticheskikh sistem [Mechanics of tribo-fatigue systems]. Minsk, Belorusskiy gosudarstvennyy universitet Publ., 2011. 407 p.
  36. Sosnovskiy L.A. Osnovy tribofatiki: uchebnoe posobie [Fundamentals of tribo-fatigue: guide]. Gomel, Belorusskiy gosudarstvennyy universitet transporta Publ., 2003, vol. 1, 246  p., vol. 2, 234 p.
  37. Sosnovskiy L.A. Mekhanika iznosoustalostnogo povrezhdeniya [Mechanics of wear-fatigue damage]. Gomel, Belorusskiy gosudarstvennyy universitet transporta Publ., 2007. 434 p.
  38. Sosnovskiy L.A., Zhuravkov M.A., Sherbakov S.S. Fundamentalnye i prikladnye zadachi tribofatiki: kurs lektsiy [Fundamental and  applied problems of tribo-fatigue: course of lectures]. Minsk, Belorusskiy gosudarstvennyy universitet Publ., 2011. 488 p.
  39. Trenie. Koeffitsienty treniya. Tribotekhnika — nauka o trenii [Friction. Coefficient of friction. Triboengineering — science of friction]. Available at: https://dpva.ru/Guide/GuidePhysics/Frication/ (accessed 16 September 2018).
  40. Bufeev V.A. Yavlenie vozdeystviya prostranstvennoy sistemy aktivnykh sil na protsess treniya (yavlenie superkulonova, ili  nadkulonova vneshnego treniya) [Action of three-dimensional system of active forces on friction (phenomenon of supercoulomb external friction)]. Trenie i iznos [Friction and  wear], 1996, no. 1, pp. 50–57.
  41. Bufeev V.A O mekhanofriktsionnom effekte i sile vneshnego treniya [The mechanofrictional effect and the force of external friction]. Trenie i iznos [Friction and wear], 2000, vol. 21, no. 5, pp. 474–480.
  42. Markov D.P. Tribologiya i ee primenenie na zheleznodorozhnom transporte [Tribology and its application in railway transport]. Moscow, Intekst Publ., 2007. 408 p.
  43. State Standard 30638–99. Tribofatika. Terminy i  opredeleniya [Tribo-fatigue. Terms and definitions]. Minsk, Mezhgosudarstvennyy sovet po standartizatsii, metrologii i  sertifikatsii Publ., Belorusskiy gosudarstvennyy institut standartizatsii i sertifikatsii Publ., 1999. 17 p.
  44. Trybafatyka [Tribo-fatigue]. Belaruskaya entsyklapedyya [Belarusian encyclopedia], 2002, vol. 15, 542 p.